Brush Drive Sprocket Shaft for Clipper M-2B Eliminator

Brush Drive Sprocket Shaft for Clipper M-2B EliminatorThis shaft is used twice on the brush drive. See arrows in the pictures. It come with two shaft collars that are used for holding the shaft in position in the machine. Dimensions: 7. 5 X 1. 5

This is the complete assemble as seen in the pictures

25" with WIRE MESH

This shaft is ¾” in diameter and is 33” long

Standard perforated metal screen with CROSS SLOTTED holes

20x48 = 400-550

Note that right hand and left hand are determined by facing the end of the cleaner where you insert the screens

This block is also used on Clipper M-2Bs that have the updated cable kit installed on the older brush drive system

This is the instruction manual that give general directions on how to operate your mill and gives the general uses of different screens

Dimensions:  39” Long x 5” wide x 1” high

Based on the design of the Clipper M2B seed cleaner

19 5/16” long

Hardened Steel Paddles