Brush Drive Sprocket & Idler Sprocket for Eliminator 224 & Clipper M-2B ball tray

Brush Drive Sprocket & Idler Sprocket for Eliminator 224 & Clipper M-2B ball trayFor Eliminator 224 & Clipper M 2B 16 tooth 5 8 bore 2 diameter steel sprocket. Two of these are used on all Eliminator 224 brush drive systems and on Clipper M 2Bs with updated gearbox brush drive systems. These sprockets are also used on Clipper M 2Bs that have the updated cable kit installed on the older brush drive system. 2 diameter

This shaft is ¾” in diameter and is 33” long

or 68D require you to cut 1 brush into two pieces and install them on the smaller H frame carrier under the scalper screen

of product with an accuracy of +/- 1/4 lb

fertilizer

New NP-7A Newlong Hand held Industrial Bag Closer with hanging spring balancer

The chain which runs the brush system with attachment link

Clipper recommends 5 balls per compartment

The angle iron measures 9” X 2” X 2”

This item does not ship to PO Boxes

This combination sheave is used on both the eccentric shaft and the fan shaft to control the speed of the fan by utilizing the 3 different pulley ratios

It also has a suggested screen list that tells you which screen to use in the top and which one to put in the bottom for the various commodities

and 68D are all 2 ½ screen cleaners so 5 brushes are needed to put all new brushes in the machine