Jazz Bass Custom - Red Pearl W/B/W Lamination S1

Jazz Bass Custom - Red Pearl W/B/W Lamination S1This pickguard will only fit genuine Fender USA made vintage Fender Jazz Bass instruments. Designed by WD to combine the pickguard and the control plate long before Fender did! Will replace JB 300 series pickguard and control plate.

This rosewood bridge will fit most archtop guitars and features and compensated wood saddle and chrome or gold thumbwheel and posts

Width at nut =43mm

For floating bridge setup this block may require some routing in the spring cavity

Made from genuine bakelite measuring 2mm thick and does not have any outer bevel around the edge of the pickguard

This tool allows anyone to tighten the jack nut quickly and easily

Note the off-set intonation screw

025" thickness nickel silver material - thicker than standard pickup covers but correct for a vintage PAF

Pre-drilled for 4 neck mounting screws and 6 hole vintage tremolo bridge with a spacing of 56mm centre to centre of the two outer holes

SUNG IL BM002

This replacement pickguard is made to fit the Fender Duosonic Offset SS model

27mm (1 5/8 inches)

coil options